Randall-amplifiers NB KING100 Uživatelský manuál Strana 6

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 7
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 5
REAR PANEL FEATURES
FOOTSWITCH
The amplier includes a 3-button MIDI footswitch for switching between the 3 channels.
The amplier was designed with MIDI channel switching circuit that is compatible
with other MIDI compatible units like rackmount Eects processor. With the
amplier OFF, simply connect th 7-pin cable to MIDI IN jack on the rear panel of
the amplier. Use the MIDI THRU to connect to other MIDI compatible devices.
MIDI CHANNEL SWITCHING/STORING
Pressing and holding the channel select button for 2 seconds on the front panel
will store settings. To Store a preset or reprogram the footswitch simply press button 1
on the foot switch then if needed select the Clean (Ch 1) using the Channel select button.
Press and hold the channel select button for 2 seconds and button 1 on the footswitch is
now programmed to select the Clean (Ch 1) on the amplier. Repeat the same process
above to program button 2 on the footswitch to the Overdrive (Ch 2) and button 3 on the
footswitch to Solo (Ch 3)
.
.
MIDI CHANNEL SELECTION:
The MIDI Channel (1
-
16) is selected via an internal four position DIP switch (S1). The
MIDI Channel must be selected with the power o.
CHAN.
S1-4
S1-3
S1-2
S1-1
1
on
on
on
on
2
on
on
on
o
3
on
on
o
on
4
on
on
o
o
5
on
o
on
on
6
on
o
on
o
7
on
o
o
on
8
on
o
o
o
9
o
on
on
on
10
o
on
on
o
11
o
on
o
on
12
o
on
o
o
13
o
o
on
on
14
o
o
on
o
15
o
o
o
on
16
o
o
o
o
MIDI IMPLEMENTATION
The EMB board recognizes Program Changes or Control Changes (Not Both) on a pre-
selected MIDI channel. See the above for MIDI Channel Selection. Program changes 1
to 128 select EMB presets 1 to 128 which are saved in EEPROM memory.
Zobrazit stránku 5
1 2 3 4 5 6 7

Komentáře k této Příručce

Žádné komentáře